DefiantDandelion on Nostr: 🎯I’ve moved to ocean for the same reason. At 500W (499) I get about 81 watts per ...
🎯I’ve moved to ocean for the same reason.
At 500W (499) I get about 81 watts per TH/s and at 300W (306) I get about 92 watts per TH/s.
You mean you want to be able to go from 750W to 500W to 300W without the boards dropping their Hash rates to zero before ramping up again?
Or something else?
“Start from scratch”
I just assumed this was a procedure to not burn up the ASICs by 1) stopping hashing, 2) run fans at full speed, 3) set fans according to configuration, 4) then ramp ASICs to Energy consumption configurations, 5) monitor temperature as the ASIC ramps.
If you mean they should be able to overclock and underclock without needing to “tune” to learn the stable set points I guess I don’t know enough to have an opinion. Once the set points are “learned” you can bounce between them without “tuning” with only the procedure above between the set points.
At 500W (499) I get about 81 watts per TH/s and at 300W (306) I get about 92 watts per TH/s.
You mean you want to be able to go from 750W to 500W to 300W without the boards dropping their Hash rates to zero before ramping up again?
Or something else?
“Start from scratch”
I just assumed this was a procedure to not burn up the ASICs by 1) stopping hashing, 2) run fans at full speed, 3) set fans according to configuration, 4) then ramp ASICs to Energy consumption configurations, 5) monitor temperature as the ASIC ramps.
If you mean they should be able to overclock and underclock without needing to “tune” to learn the stable set points I guess I don’t know enough to have an opinion. Once the set points are “learned” you can bounce between them without “tuning” with only the procedure above between the set points.