Koz Ross on Nostr: Interesting #3DPrinting data point today. I'm trying (again) to print PLA on the ...

Interesting #3DPrinting data point today. I'm trying (again) to print PLA on the XPlus-3, and to that end, I ran two voluflow racetracks. One at 230C, then another at 220C: other than that, everything stayed the same.

The difference in measured voluflow before failure? 1 point, if that! The measured height at failure differered between them by less than 1mm, so for all I know, it could have been a measuring error.

npub12atwfrq4rfv7fqara6gzsgrgj7k8ngewzl5nzs46agwyxzh0e25qxlme5y (npub12at…me5y)