Michael K Johnson on Nostr: The Qidi X-Max 3 carbon filter box has to be unscrewed from the printer bodily to ...
The Qidi X-Max 3 carbon filter box has to be unscrewed from the printer bodily to change the carbon filter, because the rear support rail runs through it. It's possible to get the carbon filter in without removing the box, but once it's in it won't come back out. I asked Qidi support, and they confirmed that you have to remove the box.
npub1yrlmnr0y2ch5ycn38j2navyduf5q6tqyd0led3p7xhwmzwcrlsaq558gpm (npub1yrl…8gpm) is the X-Plus 3 the same way?
I've started a design for a replacement carbon filter box that screws to the outside and doesn't have that rail in the way, and I'll add some HEPA filters to it to reduce microplastics. I'll use the same filters as the Nevermore v6 HEPA variant. However, since it's driven by an axial fan instead of a radial fan, I'll want to reduce back-pressure, so I'll probably use three parallel HEPA filters, whereas the Nevermore v6 with two radial fans uses just one filter.
#3Printing #3Printer
npub1yrlmnr0y2ch5ycn38j2navyduf5q6tqyd0led3p7xhwmzwcrlsaq558gpm (npub1yrl…8gpm) is the X-Plus 3 the same way?
I've started a design for a replacement carbon filter box that screws to the outside and doesn't have that rail in the way, and I'll add some HEPA filters to it to reduce microplastics. I'll use the same filters as the Nevermore v6 HEPA variant. However, since it's driven by an axial fan instead of a radial fan, I'll want to reduce back-pressure, so I'll probably use three parallel HEPA filters, whereas the Nevermore v6 with two radial fans uses just one filter.
#3Printing #3Printer