Shae M Puckett 🤖🖼 on Nostr: Put the four 3x30mm machine screws through the provided holes in the mount, then add ...

Put the four 3x30mm machine screws through the provided holes in the mount, then add the dog-bone shims to the other side, each bone reaching along the arms of the mount. One side of the shim has a notch; this side goes towards the rail.

Note: If you are using a 24mm motor, you are putting it on the bottom of the mount, the side with the curved flange, so the screws will go in from the flat side of the mount. Larger motors go on the top, so the screws are inserted on the flange side.