Siff on Nostr: npub1canhd…q0fm9 If the printed piece is not damaged on the sides, you can try ...

npub1canhdnyarz4thu7zgzz3hv3nw0al770etgjjawqukxuw82ceuz6qmq0fm9 (npub1can…0fm9) If the printed piece is not damaged on the sides, you can try printing the rest and then gluing the parts together - you can figure out which layer was the last one fully printed by the height of the print, then cut the model in the slicer at that layer and print the rest. Leave 1-2 layers to accommodate for any unevenness, then sand flat and glue them. It’s not ideal, but might salvage the print and you can use it to prototype all other components.

Hope this helps.