SUPERMAX on Nostr: NOT YOUR PRINTER NOT YOUR GCODE ...

NOT YOUR PRINTER
NOT YOUR GCODE

quoting nevent1q…cc2j

As the #BambuLab users are slowly waking up to what https://blog.bambulab.com/firmware-update-introducing-new-authorization-control-system-2/ means, it's a good time to remind everyone that the writing has been on the wall from day one.

It's not a "told you so", mind. It's a "this will continue and get worse". #Bambu will continue to tighten the ratchet.

#Prusa is far from perfect, but they deliver reliable #3dprinting based on open source software at an acceptable cost.

And if you missed it: they allow you to maintain warranty with custom firmware again.

"oH wErE sRy We DoNt LiKe ThAt GeOmEtRy, UnAuThOrIzEd PrInT GoOdByE"
🖕