triskal on Nostr: Here’s the parts list for this #meshtastic build. RAK Wisblock Meshtastic Starter ...

Here’s the parts list for this #meshtastic build.

RAK Wisblock Meshtastic Starter Kit:
https://store.rokland.com/products/rak-wireless-wisblock-meshtastic-starter-kit

6dBi low-profile antenna:
https://store.rokland.com/collections/all-helium-antennnas/products/low-profile-6-dbi-n-female-omni-outdoor-915-mhz-antenna-for-helium-rak-miner-2-nebra-indoor-syncrob-it-bobcat

Antenna cable:
https://store.rokland.com/products/uflipex-ipx-mini-pci-to-n-male-pigtail-cable-extension-rg178

Waterproof junction box:
https://a.co/d/dUbIns8

USB-C mount:
https://a.co/d/3cxk9iF

5w USB-C solar panel
https://a.co/d/iWabG7k

3.7v Li-ion battery pack:
https://a.co/d/cd3RZu9

Important Note about this battery pack: the positive and negative leads were reversed when I compared it to the plug on the Wisblock board. Use a needle to lift the tiny plastic clips at the end of the wire holding the metal leads in place. Then you can pull them out (don’t force it) and slide them back each into the other side. BE SURE TO VERIFY the polarity with the Wisblock plug. You can damage the board if you put it in backwards!

Wisblock mounting bracket:
https://www.printables.com/model/891096-rak19007-wisblock-base-board-mount

2” metal washer with 5/8” hole

Rubber washer with 5/8” hole

Zip-ties, screws, etc.

A step-bit like this one is SUPER handy to drill the 5/8” holes in the junction box. I also had to use it to increase the size of the hole in the metal washer since it came with only a 1/2” hole.
https://a.co/d/3vBvNLH

quoting note1g7k…3mhu

Built two weatherproof outdoor #meshtastic relays. One with a solar panel.