K Lars Lohn on Nostr: This was the paragon print in my eleven years with the now defunct Lulzbot TAZ 4 3D ...

This was the paragon print in my eleven years with the now defunct Lulzbot TAZ 4 3D printer. The costume antlers that I made in 2019 look about as real as I could make them. There was a lot of post processing. Each PLA antler was wrapped in thin layer kaolin clay and then painted. They mounted using magnets that mated with a circlet worn under my bandana.

Amazingly they weigh only 35g. So they're very easy to wear. Sadly, by the time I finished them, the pandemic started. I have never worn this pair in public.

I did wear earlier iterations of the project in the preceding years, but none of those were as fine as these.

#3Dprinting #Lulzbot #TAZ4