Shae M Puckett 🤖🖼 on Nostr: Next slide the drive pulley onto the motor shaft. Note how the drive teeth are on the ...

Next slide the drive pulley onto the motor shaft. Note how the drive teeth are on the side closer to the motor. There's an indent in the motor bracket for your allen wrench to reach the worm screws in about the right place. (One screw should go into the flat on the motor shaft.)

The goal is to have the drive teeth on the pulley lined up with the slots in the motor bracket near the rail where the belt will go. Get it close for now. We'll adjust it later when the belt goes on.