kaybeeque on Nostr: If I'm going to get a 3D printer going, I better learn a 3D modeler. I've always been ...

If I'm going to get a 3D printer going, I better learn a 3D modeler.

I've always been intrigued by #OpenSCAD. Just used it for a very simple 'cut plan' for a 4x8 half-inch maple sheet that I'll have cut in-store to get nice clean cuts.

This will be a new benchtop with an under bench shelf, and two pieces that will start to turn part of a closet into a 3D printer enclosure. Enough offcut for the vertical supports for the under bench shelf and other things.

I like this so far! 👍