What is Nostr?
Shae M Puckett 🤖🖼 /
npub1eca…vn5n
2024-06-10 15:57:14

Shae M Puckett 🤖🖼 on Nostr: The holes in the ends of the y rails (60cm) need to be tapped to hold a 5mm machine ...

The holes in the ends of the y rails (60cm) need to be tapped to hold a 5mm machine screw. So use the thread tap to tap all four of the holes. Use soap on the tap to keep it from binding. Remember to advance two turns to cut thread, then back off one turn to break the swarf. Repeat until the tap is all the way in, then back it out slowly. Metal shavings are sharp. Do this where you can sweep, and away from pets. (no illustration)
Author Public Key
npub1ecajqd3xcrqczcrzhx3pa6ffjfcsdvk96dgssnjyfe4n9zmmw2ns7uvn5n